![]() You can also select the anchor position on the map, after the Anchor alarm is enabled, tapping on the Anhor alarm circle, you get a pop-up menu with the option to move the anchor position manually. You can manually enter the anchor position coordinates tapping on the coordinates below the "Anchor position" label. You can restart the whole Anchor position process tapping on the "Set with GPS" button near the "Anchor position" label. If not, then select the " B" option, record your gps position with the "Capture GPS position" button and then, pointing the device towards the position where the anchor lay on the seafloor, enter the distance to it and finally press the "End procedure.If you are just on top of the seafloor anchor position, you shall select the " A" option and press the "Capture GPS position" button and then press the "End procedure.You have 2 different options to record the anchor position: After drop capture: in case you have already released your anchor and you would record its position.See " The Anchoring Process BEFORE Setting the Anchor Alarm" article for reference. It allows to define a new anchor position meanwhile you are anchoring (also giving additional useful info for the anchoring itself). Current anchor position: it starts the anchor alarm using the currently defined anchor position.See the AnchorLink page to further details. Start receiving AnchorLink: this is available only if you have the AnchorLink Mirroring enabled on another device and will start your remote Anchor alarm mode. ![]() NOTE: as " anchor position" it is intended the position where the anchor lay on the seafloor.Įach time you enable the anchoring mode you will be asked which anchor position shall be used: You shall do all your best to set it as precise as possible because all the range calculations to detect if the anchor is dragging (and so your boat position is dangerously shifting), depend on this info. Quite obviously the anchor position is a critical information for the Anchor alarm function. Anchor Alarm settingsįrom the Settings page you will find the Anchor Alarm setup page: The Anchor Alarm function will check, in realtime, your GPS position against the defined anchor position and an acoustic and visual alarm will run once your GPS position is out of the selected range. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |